400-850-4050

Nondestructive Inspection

 

Visual Inspection Nondestructive Inspection
Tensile Testing Surface Crack Detection
Bend Test Impact Test
Hardness Test Low Times Metallographic Test

 

X-ray inspection

Testing range:

Full penetration butt weld, T-joints, pipes, fillet weld and so on.

X-ray inspection is one of accurate and reliable methods to test defects inside the welding line. The shape, position and size of defects inside the welding line can be detected. The principle of X-ray inspection: it uses different degrees of high-energy X-ray to penetrate opaque objects making photographic film to be light-sensitive, thereby performing welding inspection. Surface inspection must be carried out prior to X-ray inspection for welding line. The irregular degree of surface should not impede the identification of defects on the film; otherwise it should be to recover.

 

Ultrasonic Testing Technology

Testing range:

Full penetration butt weld, T-joints, pipes, fillet weld and so on.

Ultrasonic testing level is divided into A, B, C three detection levels. Ultrasonic testing level selection should be consistent with the manufacture, installation, use and other relevant norms, standards and design drawings.

 

Level requirements for different detection techniques

1.A level detection A level detection technology is suitable for supporting structures related to pressure equipment in welded joint testing.

2.B level detection B level detection technology is suitable for general pressure equipment in welded joint testing.

3.C level detection C level detection technology is suitable for important pressure equipment in welded joint testing. When using C level detection for welded joint testing, the weld reinforcement should be polished.

 

The main point of the base metal detection is as follows:

Testing method: Contact pulse reflection method, with a frequency of 2MHz ~ 5MHz straight probe, wafer diameter 10mm ~ 25mm.

Detection sensitivity: Adjusting the second wave to display 100% full of scale where there is no defect.

When the defect signal amplitude exceeding 20% of full scale, it should be marked on surface and recorded.

 

Schematic of double holes measuring probe frontier and K values

 

Determination of defect position

 

Horizontal positioning method:

When the instrument is at the level of 1:n to adjust scanning speed, horizontal positioning method should be adopted to determine the position of defect. If the instrument is at the level of 1: 1 to adjust the scanning speed, the cutting-edge of defects wave (simulator) on the screen corresponding to the horizontal scale value is the horizontal distance of the defect. 

 

Depth positioning method:

When the instrument is at the depth of 1:n to adjust scanning speed, depth positioning method should be adopted to determine the position of defect. If the instrument is at the depth of 1:1 to adjust the scanning speed, the cutting-edge of defects wave (simulator) on the screen corresponding to the horizontal scale value is the horizontal distance of the defect.



  • Contact Us
  • MTT Shenzhen

    Tel: 400-850-4050

    Fax: 0755-2782 1672

    Email: marketing@mttlab.com

     

    MTT Suzhou

    Tel: 400-118-1002

    Fax: 0512-6275 9537

    Email: marketing@mttlab.com

     

    MTT Shanghai

    Tel: 400-118-1002

    Email: marketing@mttlab.com

     

    MTT Dongguan

    Tel: 400-116-1002

    Email:marketing@mttlab.com

Shenzhen Meixin Testing Technology Co., Ltd.

微信